P2115
Throttle/Pedal Position Sensor D Minimum Stop Performance
Here the controller judges position signal D at the released (minimum) end of travel. On Ford and GM drive-by-wire systems D is the first accelerator pedal sensor, so the code means the pedal's idle reading is outside the expected window, for example because the pedal does not return fully or its sensor track has shifted. No manufacturer documents P2115 publicly; Ford and GM publish only circuit and correlation codes for D (P2120-P2123, P2138). P2116 and P2117 are the E and F counterparts, P2109 and P2113 refer to A and B. The engine may not return to idle cleanly, and the ECU may limit pedal response.
Possible causes
- Pedal blocked by floor mat or weak return spring high
- Worn pedal sensor track D at the idle end medium
- Aftermarket pedal tuning module or wrong pedal part low
- Corroded or loose pedal connector low
Symptoms
- Warning lamp on
- Engine does not drop to normal idle when the pedal is released
- Dull or limited pedal response
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2115
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.