OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2102

Throttle Actuator A Control Motor Circuit Low

P2102 means the output stage for throttle motor A sees a voltage or current that points to a short toward ground or an overloaded driver. GM lists P2100-P2103 together in its 2018 calibration as faults that limit engine power and default the throttle authority; a Bosch-based GM ECM of 2012 assigns its output-stage checks (short circuit, overtemperature or overcurrent, open load) to this group with about 0.1 s detection. Apart from such tables, no maker publicly documents P2102 on its own; many current ECUs report the same fault under P2100 with a failure-type byte. CARB requires circuit faults of output components to be detected. The throttle drops to limp position and power is cut. The high-side counterpart is P2103.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 02

Possible causes

  • Motor wire chafed through and shorted to ground high
  • Shorted winding or jammed motor drawing excess current medium
  • Water in the throttle connector bridging terminals medium
  • Faulty throttle driver in the engine control unit low

Symptoms

  • Limp mode with throttle at fixed opening
  • Engine warning lamp on
  • Pedal input largely ignored

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2102

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication