OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2100

Throttle Actuator A Control Motor Circuit/Open

P2100 reports an electrical fault in the drive circuit of the first electronic throttle motor, usually an open line. Ford's 2012 summary uses it for an open circuit or a short to power or ground (no MIL, wrench lamp). GM's 2023 table 23OBDG07 checks the bank 1 H-bridge three ways: open load above 200 kOhm, driver overtemperature and short to ground below 0.5 Ohm, each in one trip. Ford's 2024 summary even uses P2100 as the base code for several throttle faults with failure-type bytes. Ducati reports P2100 for the front-bank throttle motor of its V4. The throttle springs to limp position, so the engine runs with little power. Wrong position is P2101; low/high circuit are P2102/P2103; the B actuator is P210A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number1 / 00

Possible causes

  • Moisture or corrosion in the throttle body or ECU connector high
  • Broken or chafed motor wire between ECU and throttle body medium
  • Open winding or worn brushes in the throttle motor medium
  • Damaged H-bridge output stage in the engine control unit low

Symptoms

  • Throttle held in limp position, very low power
  • Engine or ETC warning lamp on
  • Little or no response to the accelerator pedal

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2100

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication