OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20FC

Reductant Pump B Control Circuit Low

P20FC sets when the drive signal for reductant pump B reads too low, typically a ground fault on the line or a current draw beyond what the driver allows. Pump B has no published limits. For pump A, Ford's 2023 diesel summary reports the low fault (P208C) when pump current exceeds 5 A or the pump controller draws more than 15 A, checked with the driver off and confirmed after about 8 seconds; a similar logic is likely for pump B but undocumented. The only codegenau manufacturer evidence comes from Ford: 2023–2024 Super Duty and F-650/F-750 6.7L trucks may log P20FC alongside P20FA and P20FD, and the SSMs point to wet or corroded connectors first. Unlike P20FA, the circuit is not open but pulled down; unlike P20FD it is not stuck high.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / FC

Possible causes

  • Chafed wire shorting the pump B control line to ground high
  • Water ingress or corrosion in the pump connectors high
  • Pump B motor drawing excessive current (internal short or tight motor) medium
  • Faulty output stage in the control module low

Symptoms

  • Malfunction indicator lamp on
  • DEF system warning and reduced or no reductant dosing
  • Restart lockout after the inducement countdown if left unrepaired

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20FC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication