OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20F8

Intake Manifold Runner Control Circuit Performance (Bank 1)

P20F8 means the intake manifold runner or swirl flaps on bank 1 do not follow the commanded position, judged by comparing set point and feedback from the position sensor. Unlike P2004/P2006, which state a direction (stuck open or closed), this code reports poor tracking anywhere in the travel. GM's 2018 diesels set it when the tracking error exceeds 10 % in 80 of 100 samples, with coolant at 60 °C or more and the smart actuator powered for at least 5 s, as a Type B code; the 2025 diesel table 25OBDG04B uses the same 10 % limit over 960 of 1,200 counts for a DC swirl motor. Mazda found P20F8 on 2023–2025 Mazda3, CX-30, CX-5 and CX-50 caused by the swirl valve motor overheating from frequent actuation and fixed it with new PCM software (bulletin 01-003/26). Drivers notice the MIL and sometimes rough idle or weaker low-end torque.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / F8

Possible causes

  • Flaps or shaft sticking from carbon and oil deposits (common on diesels with EGR) high
  • Worn or overheating actuator motor or failed position sensor medium
  • Control software needing an update (Mazda bulletin 01-003/26) medium
  • Wiring or connector fault at the actuator low

Symptoms

  • Malfunction indicator lamp on
  • Rough idle or hesitation at low speed
  • Less torque at low engine speed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20F8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication