P20E2
Exhaust Gas Temperature Sensor 1/2 Correlation (Bank 1)
P20E2 flags that bank 1 exhaust temperature sensors 1 and 2 disagree at a moment when both should show nearly the same value. Sensor 1 usually sits ahead of the oxidation catalyst and sensor 2 behind it. GM runs this check on the 6.6 L Duramax LML/LGH (table 15OBDG09) and on the diesel of table 15OBDG04: after at least 28,800 s (8 h) with the engine off, the two readings captured at start-up are compared, and a gap above a limit taken from a look-up table counts as a Type B fault, so the MIL lights after two failing trips. A sensor that is offset but still inside its valid voltage window passes the circuit checks P0544 and P2031–P2033 and is only caught here. Drivers rarely notice more than the lamp, although GM blocks some regeneration functions while this code is active.
Possible causes
- Exhaust temperature sensor 1 or 2 drifted or aged (offset reading) high
- Corroded or loose connector adding resistance to one sensor signal medium
- Sensors swapped or a non-matching replacement part installed low
- Engine control software needing an update low
Symptoms
- Malfunction indicator lamp on, often with no change in driving
- Particulate filter regeneration delayed or blocked
- Code returns after a long parking period
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P20E2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.