P20DB
Exhaust Aftertreatment Fuel Supply Control Stuck Open
The supply valve that should isolate the exhaust doser from the fuel system stays open after being switched off, so the feed line remains pressurized when no regeneration is running. If the doser itself then leaks, fuel can reach the hot exhaust unasked. Ram names P20DB together with P20CF (doser A stuck open) on 2025–2026 Ram 2500/3500 trucks with the 6.7 L Cummins HO, where a PCM software update is the fix. Hino found that its fuel cut valve could hang and leave too much pressure trapped in the doser feed pipe, and released an improved valve. The circuit is fine here; stuck closed is P20DC, electrical faults P20D7, P20D9 and P20DA.
Possible causes
- Supply or fuel cut valve sticking open from wear or dirt high
- Detection or control calibration error, fixed by software medium
- Contaminated fuel leaving deposits in the valve low
Symptoms
- Check engine light on
- Fuel smell or smoke if the doser also leaks
- Long cranking after fuel system work
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P20DB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.