P20CD
Exhaust Aftertreatment Fuel Injector A Control Circuit Low
Here the control line of the hydrocarbon doser has a short to ground. GM's diesel tables 18OBDG04 and 25OBDG04A test the output while the driver is off: if the voltage drops below about 2 V, the line is touching ground. GM rates it Type A, which lights the MIL after one trip, and the fault only clears after a calibrated count of good tests or a control-module reset. The LML/LGH Duramax lists it as Type B. A grounded line can make the doser open whenever its supply side is switched on, so fuel may enter the exhaust uncontrolled; that is why it is treated more strictly than the open circuit (P20CB) or the short to power (P20CE).
Possible causes
- Control wire chafed through against the frame or exhaust high
- Water or salt in the doser connector bridging to ground medium
- Internal short in the doser solenoid low
Symptoms
- Check engine light on after a single trip
- Doser disabled, no active regeneration
- Possible fuel smell or smoke from the exhaust
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P20CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.