P20C7
Reductant Heater D Control Circuit Low
P20C7 reports that heater D's control circuit is grounded or overloaded with current. Only Deutz publishes the code: for its downstream line heater (SPN 520471) it maps to FMI 4, a voltage that is too low or a short to a low source. No vehicle maker documents thresholds for heater D. GM's tables for heaters 1–3 show the usual method, comparing the output voltage with the heater off against a low band and the current with it on, then setting Type A, set after a 2 s window; Ford uses 15 A on its two heater circuits. CARB requires such output circuits to be monitored for shorts that contradict what the module has commanded. Look for chafing on the line harness, water in a connector or an element with an internal short. Open and high counterparts are P20C5 and P20C8, the performance test is P20C6.
Possible causes
- Heater D wire chafed through to ground high
- Water in the heater D connector medium
- Internal short inside the heated downstream line low
Symptoms
- Warning lamp, possibly with a blown fuse
- Unheated downstream line and delayed dosing in frost
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P20C7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.