Powertrain
generic / SAE
P20C3
Reductant Heater C Control Circuit Low
Reductant heater C control line stuck low — short to ground. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / C3
Possible causes
- Short to ground high
- Connector pins corroded - high contact resistance low
- Harness chafing through insulation low
Symptoms
- Check engine light or NOx warning on
- AdBlue/DEF level or quality warning
- Possible no-start countdown after ignore period
- Failed emissions inspection (NOx)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 80–800 €
- Estimated time: 0.7–3 h
- Component: reductant line heater c
- MIL / check engine light
- emissions-relevant
Sources
References
sae:J2012