P20C2
Reductant Heater C Control Circuit Performance
P20C2 says heater C is connected but does not take the power the control unit expects. In GM's 2025 tables heater 3, the second tank heater, must measure between 1.50 and 2.60 ohms and stay within 29 W of its command; otherwise Type A after 8 s. Ford reads the code differently on its diesels: there it means the heater supply voltage has dropped below 5 V, tested a single time per trip with the heaters at full load and again within the glow plug module diagnostics, so a weak feed or relay is the first suspect. FCA titles it Reductant Heater 3 Control Circuit Performance on the 3.0 L EcoDiesel and issued several PCM reflashes against false entries, among them 18-028-14 and 18-019-15. Deutz lists it for the return line heater as over-temperature. The usual result is late dosing in frost.
Possible causes
- Heater supply below 5 V because of a weak relay, fuse or feed wire (Ford) high
- Engine control software setting the code falsely (FCA 18-028-14, 18-019-15) medium
- Heater C element resistance outside its window medium
Symptoms
- Check engine light after a heating cycle
- DEF thaws slowly in cold weather
- Further heater codes if the common supply is weak
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P20C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2025/25OBDG04A.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- static.nhtsa.gov/odi/tsbs/2015/MC-10144805-9999.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10139634-9999.pdf
- serdia.deutz.com/fileadmin/contents/serdia/DTCList_MD1_DE_EN.pdf