OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20BF

Reductant Heater B Control Circuit Low

For heater B the code stands for a grounded control circuit or an overcurrent. Ford, where B is the pressure line heater, sets it when circuit 2 draws more than 15 A with the power stage on; the glow plug module can report such a short within 250 ms. GM's 2025 DEF module applies to heater 2 (line heater) the same low-band and overcurrent tests it uses on the tank heater, Type A, confirmed within 2 s, and in 2018 relied on a short-to-ground status from the DEF control module. VW's Touareg CNRB stores P20BF below 2.97 V signal voltage; Deutz lists FMI 4, a voltage too low, for its pressure line heater. Chafed line harnesses along the frame and water in connectors are typical. Because the driver shuts down or a fuse fails, the pressure line stays unheated in winter.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / BF

Possible causes

  • Line heater wire chafed on the frame and grounded high
  • Water in the line heater connector creating a path to ground medium
  • Internal short in the heated pressure line medium

Symptoms

  • Check engine light, sometimes with a blown fuse
  • DEF pressure fault codes in cold weather
  • Speed limitation if the fault persists

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20BF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication