P20BD
Reductant Heater B Control Circuit/Open
Heater B's control circuit is open. In GM's tables heater 2 is the DEF line heater; the 2025 version detects the open state with the output off and sets a Type A code after two seconds, while the 2018 version relies on an open status reported by the DEF control module with battery voltage above 11 V. Deutz assigns B to the pressure line heater, the hose from pump to dosing valve. Hino numbers differently: its 2018 bulletin calls P20BD heater 1 of the heated DEF line on J05 cab-overs and asks for a resistance check at the 6-pin connector before the line assembly is replaced. On the Touareg CNRB, VW stores the code when the power stage's diagnostic signal drops below 4.70 V. A frozen pressure line delays or blocks dosing in cold weather. Short circuits of the same element are P20BF and P20C0.
Possible causes
- Heating wire in the pressure line broken (line assembly replacement) high
- Corroded or unplugged line heater connector medium
- Harness to the line heater damaged along the frame rail medium
Symptoms
- Warning lamp, especially after cold nights
- DEF pressure builds slowly or not at all in frost
- Inducement countdown with eventual speed limit
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P20BD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.