OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20BC

Reductant Heater A Control Circuit High

P20BC means the heater A control circuit reads high: the wire or output has picked up battery voltage, so the element may run when it should be off or cannot be switched at all. GM's 2025 DEF tables spot this on heater 1 (tank heater 1) mostly in the off state, when the high-side voltage lies between roughly 2 and 4.3 V instead of near zero; Type A after a 2 s debounce. Ford's criterion is current below 3 A with more than 5 V at the output while the power stage is off. GM's 2014 tables for the 6.6 L LML, where the glow plug module drives the heaters, look for more than 3.5 V at the heater pin (Type B). On the Touareg CNRB, VW sets it above 2.20 A signal current. For 2025 Ram 2500–5500 with the 6.7 L Cummins, FCA names P20BC the suction line heater and fixes it with DCU software (08-076-26).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / BC

Possible causes

  • Heater A control wire shorted to a battery-voltage circuit high
  • DEF control unit software fault (FCA 08-076-26 for 2025 Cummins Ram) medium
  • Heater output stage or relay stuck switched on low

Symptoms

  • Check engine light and DEF system warning
  • Heater may stay energized, risking overheating or a drained battery
  • Reduced power or speed limit once the inducement starts

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20BC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication