OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20BB

Reductant Heater A Control Circuit Low

A low reading on the heater A control circuit usually means the output or its wire is grounded, or the element pulls far more current than it should. GM's 2025 DEF module checks heater 1 (tank heater 1) in both states: switched on, a low-side drain voltage above 0.45 V or a load current above 95 A counts; switched off, the high-side voltage sitting in a low band near 0.5–0.6 V. Two seconds of failures give a Type A fault. Ford logs P20BB on circuit 1 above 15 A and lets the glow plug module report it within 250 ms; VW uses a signal voltage under 2.97 V on the 2014 Touareg. On 2020–2022 Silverado and Sierra diesels GM found the test itself setting P20BB falsely and released new DEF module calibrations (22-NA-112). Expect a warning lamp and, later, a speed limit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / BB

Possible causes

  • Heater A wire chafed through and touching ground high
  • Internal short in the heater element, drawing excessive current medium
  • DEF control module calibration setting the code falsely (GM 22-NA-112) medium
  • Moisture bridging heater pins to ground in the connector low

Symptoms

  • Malfunction indicator lamp, possibly with a blown heater fuse
  • Message that speed will be reduced if the system is not serviced
  • No DEF heating, so dosing is delayed in frost

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20BB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication