P20B8
Reductant Metering Unit Heater Control Circuit High
P20B8 marks the upper limit of the metering unit heater circuit. The 2014 Touareg CNRB table from Volkswagen sets it when the conductance measured at heating start exceeds 0.74 siemens, meaning the element is below about 1.35 ohms, with additional limits at 0.96 and 0.52 siemens. Such high conductance suggests shorted heater windings, wires touching each other or fluid bridging the terminals, and it implies excess current that strains the driver stage and wiring. The control unit will normally switch the heater off for protection, so in winter the outcome resembles an open heater (P20B5). Makers that judge their outputs by voltage may use the same code for a short to battery instead.
Possible causes
- Heater element internally shorted (too low resistance) high
- Heater wires chafed and touching each other medium
- DEF or water bridging the heater terminals low
Symptoms
- Warning lamp as soon as heating is requested
- Heater switched off, DEF stays frozen longer
- Possibly a blown heater fuse
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P20B8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.