OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20B7

Reductant Metering Unit Heater Control Circuit Low

P20B7 means the metering unit heater circuit reads low. Volkswagen gives this a concrete meaning for the 2014 Touareg CNRB: the control unit checks heater conductance at the start of heating and flags P20B7 below 0.33 siemens, so the element shows more than about 3 ohms; further stages at 0.18 and 0.04 siemens follow. In VW's logic, low therefore refers to conductance, not to voltage, and points to a degraded element, a high-resistance joint or a partly broken wire rather than a short to ground. Other makers may define the low case through the output-stage voltage instead, since their drivers differ. The module receives too little heat, and thawing after a frosty night takes longer.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / B7

Possible causes

  • Heater element resistance too high (aged or partly damaged) high
  • Contact resistance at the heater terminals medium
  • Heater wire partly broken (few strands left) medium

Symptoms

  • Warning lamp at the start of a cold-weather heating phase
  • DEF dosing delayed in winter

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P20B7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication