OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20AF

Reductant Metering Unit Temperature Sensor Circuit High

P20AF means the metering unit temperature signal has risen above its permitted band. For an NTC thermistor, the likely design though not publicly confirmed for this part, that looks like an extremely cold module. Electrically it is usually an open signal or ground wire, a terminal backed out of the connector or a short to a voltage source. Corrosion deserves attention: Hino's bulletins SB-16-015 and SB-16-016 explain that frozen DEF can damage the pump and let fluid creep into the pump connector and SCR harness; Hino names its own P142A there, not P20AF. Believing the module frozen, the control unit holds back dosing and may keep heating. No maker publishes P20AF itself.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / AF

Possible causes

  • Open signal or ground wire to the temperature sensor high
  • DEF intrusion and corrosion in the pump connector or harness medium
  • Signal wire shorted to a supply voltage low
  • Sensor element in the metering unit open medium

Symptoms

  • Module temperature shown far below ambient in live data
  • DEF warning and delayed or missing dosing
  • Further SCR codes if the harness is corroded

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20AF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication