OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20AE

Reductant Metering Unit Temperature Sensor Circuit Low

P20AE is stored when the signal of the metering unit temperature sensor falls below its valid band. If the sensor is an NTC thermistor, the common design, though no maker confirms it publicly for this part, a low voltage stands for a very high indicated temperature. Typical reasons are then a signal wire chafed through to ground, moisture or DEF crystals bridging the connector pins, or a shorted sensor element. No manufacturer reference names this exact code; CARB merely requires the input to be checked for out-of-range values. The control unit then usually discards the reading and may suspend dosing. The upper counterpart is P20AF, while unclear electrical faults go to P20AC.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / AE

Possible causes

  • Signal wire shorted to ground (chafing near tank or frame) high
  • Water or DEF residue bridging the connector pins medium
  • Sensor element in the metering unit shorted medium

Symptoms

  • Warning lamp on immediately after key-on
  • Module temperature shown far too hot in live data
  • DEF dosing suspended, inducement countdown possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20AE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication