P20AB
Reductant Injection Air Pressure Control Valve Stuck Closed
The opposite of P20AA: the air pressure control valve does not open although the controller commands it, so no atomizing air reaches the DEF dosing point. The air pressure sensor stays near ambient during dosing requests. Without air, an air-assisted dosing module cannot spray the fluid into fine droplets, and the risk of liquid DEF and deposits in the exhaust grows; controllers therefore stop dosing, NOx rises and heavy vehicles move toward a derate. No manufacturer documents P20AB publicly; Deutz files low air pressure under its own code P1124 and a blocked air path at the injector under P1123. Before condemning the valve, check the supply pressure from the vehicle air system, a frozen or kinked line and the air filter. P20A6 to P20A9 indicate electrical causes instead.
Possible causes
- Valve seized by corrosion or deposits high
- No supply pressure, for example low air reservoir or closed protection valve medium
- Air line frozen with condensate or kinked medium
Symptoms
- MIL or SCR warning on
- Air pressure stays at zero when dosing is requested
- Power derate or inducement on trucks
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P20AB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.