OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20A9

Reductant Injection Air Pressure Control Valve Circuit High

If the control line of the air pressure control valve shows battery voltage or excessive current where it should not, P20A9 is stored. A wire touching a positive feed, a coil with shorted turns or a bridged connector can cause it. On a low-side driven valve the coil would then be live permanently; on a high-side driver the output often detects overcurrent and shuts down. Either way the atomizing air no longer follows the commands. P20A8 is the matching short to ground and P20A6 the open circuit. No manufacturer publishes P20A9. Deutz handles the comparable faults on its air pump or supply valve as P2061 for a short to battery and P2059-19 for critically high output current. Because the air supply is shared, check for further codes on the air pressure sensors before replacing parts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / A9

Possible causes

  • Coil with shorted turns causing overcurrent high
  • Control wire shorted to a positive feed in the harness medium
  • Output stage in the dosing control unit defective low

Symptoms

  • Warning lamp on
  • Air pressure uncontrolled, often too high or permanently on
  • DEF dosing suspended

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20A9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication