OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20A8

Reductant Injection Air Pressure Control Valve Circuit Low

P20A8 says the air pressure control valve's drive circuit sits at too low a level, which normally means a short to ground. Depending on whether the valve is switched on the high or the low side, this either stops the valve from opening at all or energizes it without command. In both cases the controller loses control of the atomizing air. The fault differs from P20A6, where the circuit is interrupted, and from P20A9, a short toward battery voltage. No manufacturer documents P20A8 publicly. For the comparable valves of its air-assisted system, Deutz lists the high-side short to ground as P2060 on the air pump or supply valve and as P1061 on the air switching valve. CARB requires such circuit checks on every electrical component of the SCR system. A chafed harness on the frame rail is the classic finding.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / A8

Possible causes

  • Harness chafed through to ground along the frame high
  • Solenoid coil shorted to the valve body medium
  • Water in the connector creating a path to ground medium

Symptoms

  • MIL or SCR lamp on
  • Blown fuse possible on high-side switched valves
  • Dosing stopped, derate on trucks

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20A8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication