OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20A3

Reductant Purge Control Valve A Circuit High

P20A3 is the high-side fault of the purge valve circuit: the line carries voltage or current where it should not. GM detects it on the 6.6 L Duramax while the low-side driver is switched on; an impedance of less than 0.5 Ω to controller power lasting 3 s triggers it as a Type A fault. Volkswagen's test for the 2014 Touareg V6 TDI (engine CNRB) looks at current instead and reports P20A3 above 3.00 A, which indicates a short across the coil or to battery positive. A driver that sees such overcurrent switches off to protect itself, so the valve no longer reverses the pump, and the line is not emptied at shutdown. P20A2 covers the opposite short to ground and P20A0 the open circuit. Look for a shorted coil, a wire touching a supply cable or a damaged connector at the supply module.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / A3

Possible causes

  • Valve coil with shorted windings drawing excessive current high
  • Control wire shorted to a battery-fed conductor medium
  • Damaged or DEF-contaminated connector bridging pins medium

Symptoms

  • MIL on in the first trip (GM Type A)
  • DEF warning and possibly further pump codes
  • In frost, risk of DEF freezing in the line

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20A3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication