OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P20A0

Reductant Purge Control Valve A Circuit/Open

After the engine stops, many airless DEF systems suck the fluid out of the line and injector back into the tank so that nothing freezes there. In Bosch's Denoxtronic 2.2 this is done by a 4/2-way valve in the supply module that reverses the flow. P20A0 concerns the drive circuit of this valve, chiefly an interruption. GM checks it on the 6.6 L Duramax (LML/LGH) with the driver switched off: an impedance above 200 kΩ between ECM pin and load for 3 s sets the code, Type A. Volkswagen, on the 2014 Touareg 3.0 TDI (CNRB), uses a power-stage voltage between 2.97 and 4.70 V. Shorts to ground and to power are split off as P20A2 and P20A3. If the line cannot be emptied, DEF may stay in the injector and line and freeze there in winter.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / A0

Possible causes

  • Coil of the purge or reversing valve open high
  • Connector at the supply module loose or corroded by DEF high
  • Wire to the valve broken medium
  • Output stage in the engine or dosing control unit defective low

Symptoms

  • MIL on (GM Type A, first trip)
  • DEF system or emission service message
  • Risk of frozen DEF line or injector in winter

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P20A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication