P209D
Reductant Injection Air Pressure Sensor B Circuit High
With P209D the second air pressure sensor reports a voltage above the top of its usable range, close to the supply or battery level. A real air pressure that high is not possible in the system, so the controller treats the value as an electrical fault. Usual explanations are a signal wire that touches a live conductor, a broken ground return so that the output floats up to the reference, or an open signal line on circuits that pull the input high. P209C is the mirror case with a reading too low, and P209A the umbrella code when the type of circuit fault cannot be narrowed down. P209D does not appear in any public manufacturer list; Deutz assigns the corresponding short to battery on sensor A to P2040. The SCR controller stops dosing because it can no longer confirm atomization, and the warning lamp comes on.
Possible causes
- Sensor ground open at the connector or splice high
- Signal wire shorted to the 5 V reference or battery voltage medium
- Sensor B output stage failed high medium
Symptoms
- Warning lamp on, dosing stopped
- Displayed air pressure stays at an impossibly high value
- Inducement countdown on heavy vehicles if not repaired
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P209D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.