OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P209B

Reductant Injection Air Pressure Sensor B Circuit Range/Performance

Here the wiring of air pressure sensor B is intact and the voltage lies inside its valid band, yet the reported pressure makes no sense for the moment. Typical checks compare the value with the switching state of the air supply: pressure must rise when air is released to the mixing chamber and fall back when it is shut off, and with the system at rest it should sit near ambient. A sensor that sticks, drifts or reacts too slowly fails these tests. No manufacturer publishes P209B; Deutz reports such plausibility errors on its single air pressure sensor with its own code P1119. Besides the sensor, a leaking air line, a sticking supply valve or a clogged sensing port can produce the same picture. CARB requires rationality checks for every input the dosing strategy relies on.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 9B

Possible causes

  • Sensor B drifting or responding sluggishly high
  • Leak in the atomizing air line between valve and dosing module medium
  • Sensing port blocked by urea crystals or dirt medium
  • Air supply valve sticking, so the expected pressure change does not occur low

Symptoms

  • Check engine or SCR warning lamp
  • Dosing reduced or stopped, possible NOx efficiency codes later
  • No noticeable change in driving until an inducement starts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P209B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication