OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2095

"B" Camshaft Position Actuator Control Circuit High (Bank 2)

P2095 closes the series: the bank 2 exhaust phaser valve (actuator B) shows a high level on its control line. For the 3.6 L LFX, GM table 19OBDG03B describes a high-side driver that finds a short to supply with the output off and sets a Type A code after 20 failures in 25 samples. In table 23OBDG07 a low-side controller watches the pin while the driver is on and confirms the short to power after 1 s, Type B style with two trips. Ford's 2014 petrol list contains P2095 with lamp marking, monitored continuously. In the workshop, measure the valve coil, then check the control wire for voltage with the connector unplugged and the ignition on; any voltage there points to the harness, not the valve. The engine runs on with a fixed exhaust cam. P2094 is the Low counterpart, P0023 the open circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 95

Possible causes

  • Bank 2 exhaust valve wire shorted to a supply wire high
  • Bridged pins in the valve or engine harness connector medium
  • ECM output stage defective low

Symptoms

  • Engine warning lamp on
  • Exhaust cam on bank 2 fixed, minor drop in performance

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2095

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication