OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2093

"A" Camshaft Position Actuator Control Circuit High (Bank 2)

P2093 reports too high a level on the control line of the bank 2 intake phaser valve (actuator A). Table 23OBDG07 shows why High and Low are not tied to one wiring fault: that GM controller switches the valve on the ground side, so it checks for voltage with the driver switched on and calls it a short to power after 1 s, with the lamp after two trips. The 3.6 L LFX (19OBDG03B) uses a high-side driver and looks for the same short with the output off; there P2093 is Type A after 20 of 25 samples. Ford's 2014 code list names P2093 as a lamp code covered only by the continuous monitor. Typical findings are a chafed wire touching an ignition or injector feed. If P2093 and P2089 appear together, suspect a shared supply or connector rather than two valves.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 93

Possible causes

  • Bank 2 intake valve wire shorted to an ignition or injector feed high
  • Fault in a shared engine harness connector medium
  • ECM output stage defective low

Symptoms

  • Engine warning lamp on
  • Bank 2 intake timing fixed, reduced low-speed torque

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2093

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication