OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2091

"B" Camshaft Position Actuator Control Circuit High (Bank 1)

P2091 says the control circuit of actuator B on bank 1, normally the exhaust phaser valve, sits too high. GM's high-side version on the 3.6 L LFX checks for a short to supply while the output is off and, like P2090, treats it as Type A after 20 of 25 samples; 18OBDG02 uses Type B. On the low-side controller of table 23OBDG07 the same code means the pin stays at supply voltage even though the driver should be pulling it to ground, and it takes about 1 s to confirm, two trips for the lamp. Ford shows P2091 in its 2014 petrol code list as a lamp code that both key-on and running self-tests can find. A short of this kind can overheat the driver, so the ECM usually switches the output off and leaves the exhaust cam at its default angle. Out-of-range timing of the same cam is P0014 or P0015.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 91

Possible causes

  • Exhaust valve control wire touching a supply wire high
  • Incorrect splice or pin swap after earlier wiring repair low
  • Failed output stage in the ECM low

Symptoms

  • Engine warning lamp on
  • Exhaust cam stays at default angle, slightly reduced performance

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2091

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication