P2090
"B" Camshaft Position Actuator Control Circuit Low (Bank 1)
P2090 refers to actuator B, on engines with twin phasers the exhaust camshaft valve, on bank 1. What Low means depends on how the ECM drives the solenoid. GM's usual high-side output flags a ground short while the valve is energised; the 3.6 L LFX V6 (19OBDG03B) sets P2090 after 20 of 25 samples as Type A, the 2018 hybrid table 18OBDG02 as Type B. A GM controller with a low-side driver in table 23OBDG07 flips the test: it looks for a low voltage while the output is off and flags the code after only 0.2 s, two trips to the lamp. In both cases the threshold is below 0.5 ohms to ground. An open line on this valve is P0013, not P2090. With the exhaust phaser parked, the engine loses some internal exhaust recirculation and part-load efficiency.
Possible causes
- Exhaust valve control wire shorted to ground or engine block high
- Shorted coil in the exhaust oil control valve medium
- Damaged or oil-soaked valve connector low
Symptoms
- Engine warning lamp on, immediately on some GM V6 engines
- Slightly higher consumption and emissions at part load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2090
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.