OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P207C

Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Low (Bank 2)

Low signal on the position feedback of the bank 2 tuning valve: the controller sees a value below the window it accepts. Typical electrical causes are the signal shorted to ground or a missing 5 V supply. No manufacturer publishes P207C. Its bank 1 equivalent P2077 is well documented at GM, where the limit is given in percent and the scale runs backwards (95 % or more counts as low), and FCA cites P2077 for the 3.5L V6 manifold tuning valve; a bank 2 application would follow the same pattern. Ground faults can also kill other sensors on the shared 5 V circuit, so if several sensor codes appear together, look for the common reference first. P207D is the high-side fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 7C

Possible causes

  • Bank 2 signal wire shorted to ground high
  • Shared 5 V reference pulled down or open medium
  • Internal short in the bank 2 sensor low

Symptoms

  • Check engine light (manufacturer-dependent)
  • Other 5 V sensor codes at the same time

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P207C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication