OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P207B

Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit Range/Performance (Bank 2)

On bank 2, the valve feedback is electrically valid yet does not match what the flap should be doing, for instance it changes too slowly, sticks at an intermediate value or disagrees with the commanded state. No manufacturer documents P207B. The closest documented logic is GM's bank 1 code P2076, which fails the actuator learn sweep when the reported position lingers inside the 5-35 % band for five seconds, or when learning restarts ten times in one key cycle. A plausibility code like this often points at mechanics rather than electrics: a flap that binds or a slipping coupling falsifies the movement profile even with an intact sensor. Compare with P206E/P206F, which judge the end positions of the same flap.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 7B

Possible causes

  • Bank 2 flap binding, movement profile does not match the command high
  • Coupling between sensor shaft and flap slipping medium
  • Sensor characteristic drifted with age and heat low

Symptoms

  • Check engine light (manufacturer-dependent)
  • Possibly uneven power delivery

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P207B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication