OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P207A

Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit (Bank 2)

Unspecified circuit failure of the position feedback on the bank 2 tuning valve. It presupposes a second, separately sensed valve, which in practice means a V-engine with one switchable flap per bank. Nobody publishes this code: the GM tables use a single sensed valve (P2076 to P2078), and in Ford's literature only the runner control flaps (IMRC, P2004 onward) are monitored bank by bank. Following CARB, the controller still has to detect an open or shorted input even if it does not tell those cases apart. Because the bank 2 sensor usually sits at the rear of the manifold, chafed wiring under the cowl is worth checking first; for a pure bank 1 fault see P2075, for refined bank 2 fault types P207C and P207D.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 7A

Possible causes

  • Poorly accessible bank 2 connector not latched or corroded high
  • Harness chafed between manifold and bulkhead medium
  • Position sensor of the bank 2 actuator failed medium

Symptoms

  • Check engine light (manufacturer-dependent)
  • Mostly no change in driving behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P207A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication