OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2078

Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit High (Bank 1)

Opposite of P2077: the bank 1 valve feedback sits above its upper plausible limit. Typical triggers are a short to battery or 5 V on the signal line, or an open sensor ground. Because GM's percentage scale is reversed, its tables treat a position of 5 % or less as high (2007, 2015, 2018; the 2006 table names 0.05 %), with 320 failures in 400 samples and Type B. GM's newer 2023/2024 logic instead watches for a raw voltage above roughly 4.8 V. On FCA's 3.5L V6 (2007-2010) P2078 is the second manifold tuning valve code next to P2077, and the Chrysler tip warns against replacing the whole manifold before testing the actuator output. Ford lists the code without MIL. Note that GM blocks its stuck-valve checks while this code is active.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 78

Possible causes

  • Sensor ground open, e.g. pushed-back pin in the connector high
  • Signal wire shorted to 5 V reference or battery voltage medium
  • Electronics of the actuator unit defective medium

Symptoms

  • Check engine light (GM Type B; Ford without MIL)
  • Valve monitoring suspended
  • Possibly less power in one rpm band

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2078

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication