OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2075

Intake Manifold Tuning (IMT) Valve Position Sensor/Switch Circuit (Bank 1)

General circuit fault of the bank 1 tuning valve position feedback, which may be a potentiometer, a Hall sensor or a simple end-position switch. The code is meant for systems that do not split the fault into low, high or intermittent. No manufacturer publishes P2075: GM, which uses position sensing on its tuning valves, reports the same circuit through the specific P2077 and P2078, and Ford's IMTV has no feedback at all. CARB requires input components to be checked for open circuits and readings beyond their limits, but not with separate codes per fault type, which explains why such a catch-all code exists. In practice an open signal or ground wire or a bad plug is the usual cause; the flap may still work, but its function test is suspended.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 75

Possible causes

  • Corroded or loose connector at the actuator with integrated position sensor high
  • Signal, reference or ground wire chafed or broken near the hot manifold medium
  • Position sensor inside the actuator failed medium

Symptoms

  • Check engine light (manufacturer-dependent)
  • Flap position monitoring and stuck-valve tests no longer run
  • Usually no driveability complaint

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2075

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication