OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P206E

Intake Manifold Tuning (IMT) Valve Stuck Open (Bank 2)

Reserved for engines whose second cylinder bank has its own intake manifold tuning valve, the flap that switches plenum volume or runner length for resonance charging. The code says the bank 2 flap was commanded shut but its position feedback still reports it open. No manufacturer documents P206E publicly; the GM and Ford tables checked cover only a single tuning valve, logged as P2070/P2071. By analogy with GM, a fault would be counted once the closed end stop is not reached for several seconds and confirmed on a second trip. CARB lists variable-length intake runner systems as monitored output components. The driver mostly notices a torque dip in one speed band; P206F is the reverse case, P2070 the bank 1 counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 6E

Possible causes

  • Flap or shaft of the bank 2 tuning valve gummed up by oil vapour and carbon from crankcase ventilation high
  • Bank 2 actuator motor or gear worn, cannot drive the flap into the closed stop medium
  • Linkage between actuator and flap shaft detached or broken medium
  • End positions not relearned after actuator or manifold replacement low

Symptoms

  • Check engine light after two drives (manufacturer-dependent)
  • Noticeably less pulling power in one rpm range
  • Changed intake sound under acceleration

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P206E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication