OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2067

Fuel Level Sensor B Circuit Low

P2067 sets when the input from the second fuel level sender drops below its valid floor, usually a grounded signal wire or a sender resistance near zero. Ford's saddle-tank trucks flag it below 5 ohms (under one A/D count) and allow 30 s for the electrical check. GM's 2020 table, written for dual-tank vehicles, sets it when the secondary sender reads under 10 % of its 5 V range in 100 of 125 samples; Type B, two trips. Mercedes lists it as P206700, the secondary fill level sender grounded. Two bulletins point away from the tank: on 2021 Pacifica and Voyager the code appeared on front-drive vans running all-wheel-drive PCM software, and Genesis issued an ECM logic update for P2067 on the 2018 G80 5.0, where Hyundai calls sensor B the main sender. Driving is unaffected; the gauge is not.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 67

Possible causes

  • Sender signal wire shorted to ground or chafed on the tank strap high
  • Sender card shorted internally medium
  • PCM software for the wrong drivetrain or tank version medium
  • Diagnostic logic needing an ECM update (Genesis G80) low

Symptoms

  • MIL on with no change in driving
  • Fuel gauge too low, empty or dropping suddenly
  • Low fuel warning without reason

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2067

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication