P2062
Reductant/Regeneration Supply Control Circuit/Open
J2012 keeps this title deliberately broad: the controlled supply that feeds the reductant system or, in some layouts, the regeneration hardware, mostly a supply pump or the relay powering it. P2062 reports an open control circuit, so the commanded stage draws no current. No manufacturer documents P2062 publicly. Published systems monitor this function under component codes: Ford's 2023 diesels set P208A when reductant pump voltage sits between 2.6 and 3.4 V or the pump controller supply drops below 6 V, and Deutz reports an open DEF pump drive as P05EE-00. Typical causes are a blown fuse, a relay that does not close, a broken wire or a failed pump. Without supply the reductant line cannot build pressure and dosing stops; CARB treats this as part of reductant delivery monitoring.
Possible causes
- Blown fuse or relay not closing in the supply path high
- Broken wire or unplugged connector at the pump medium
- Supply pump with open winding medium
Symptoms
- Engine or emission warning lamp on
- No reductant pressure, dosing stops
- Restart countdown or speed limit on some vehicles
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2062
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.