P2060
Reductant Injection Air Pump Control Circuit Low
P2060 means the control line of the injection air pump or air valve is held at too low a level: when the output tries to switch it on, the voltage collapses because the wire or the load is connected to ground. Deutz defines exactly this on its EMR L1 controller as P2060-00, a high-side short to ground on output SPN 5796, which drives the air pump or valve. The driver protects itself, so the valve stays closed and atomizing air never reaches the dosing nozzle. Look for wires rubbed through on the frame or the engine block, a water-filled connector or a coil with a short to its housing. An open circuit of the same output is P2059, a short to battery P2061. DEF dosing is blocked until the short is removed.
Possible causes
- Control wire chafed through to ground high
- Valve or pump coil shorted to its housing medium
- Water in the connector bridging to ground low
Symptoms
- Emission warning lamp on
- DEF dosing blocked
- Possible blown fuse in the air valve supply
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2060
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.