OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P205E

Reductant Tank Temperature Sensor A Circuit Intermittent/Erratic

P205E marks a DEF tank temperature that changes faster than any real tank could. GM describes two versions: the 2018 diesel table (1.6L Cruze, 2.8L Colorado) checks whether the signal's time evolution is plausible and fails after 8 out of 10 samples taken every 500 ms, provided no electrical fault of the sensor is present; the 2025 DEF controller flags readings that jump beyond 4 °C within ten values in three of nine checks, Type A. FCA used P205E on the 2013 Ram 2500/3500 with the 6.7L Cummins and released new PCM software (18-057-15 Rev. A) because the code set when the engine block heater was plugged in, and many later Ram updates list it too. A stored P205E without other codes therefore points to software or a loose contact. Steady faults are P205C and P205D.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 5E

Possible causes

  • Engine control software, fixed by reflash (FCA 6.7L) high
  • Loose or corroded contact at the tank connector medium
  • Block heater use causing a fast temperature change low

Symptoms

  • MIL, often after cold starts
  • Jumping tank temperature in live data

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P205E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication