OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P205D

Reductant Tank Temperature Sensor A Circuit High

P205D is the top-of-range fault of the tank's temperature sensor. On voltage-read NTC sensors a high signal looks like extreme cold and typically comes from an open circuit, a lost ground or a short to supply: Ford's 2023 diesels set it above 4.3 V, GM's 2025 DEF controller above 4.75 V (about −40 °C, 0.5 s, Type A), and GM's 2018 diesel table above 60,000 Ω. On the 6.6L LML and 2014 Cruze GM reads a CAN raw value instead, where High means above 1022, i.e. 160 °C or more, the hot side (6 s, Type B). Ford's bulletin 18-2190 for 2011–2015 6.7L Super Duty treats P205D like P205C: new reductant heater and sender assembly plus PCM update. Hino names P205D next to P205B and P205C as a source of wrong DEF temperature input. The low end is P205C.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 5D

Possible causes

  • Open circuit, unplugged connector or broken ground high
  • Sensor in the heater/sender assembly open internally medium
  • Signal wire shorted to supply voltage low

Symptoms

  • MIL and DEF warning
  • Tank heater runs although the tank is warm
  • Dosing delayed after start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P205D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication