OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2054

Reductant Injection Valve Circuit Low (Bank 1 Unit 2)

P2054 flags a ground short in the switched circuit of the second DEF injector in the Bank 1 line. GM's 2025 diesel table (25OBDG04B) checks DEF metering valve 2 for this with the key on, the engine not cranking and more than 11 V, then sets a Type A code after 30 of 60 samples. Deutz uses P2054 on EMR5 engines for metering unit 2 with failure type 11, voltage below normal. Ford's 2023 diesel summary lists P2054 next to the circuit checks of its single injector but defines it as a resistance deviation below minus 2 ohm, so on a Ford the code points to a coil whose resistance has drifted low rather than to a second valve. Typical causes are a pinched wire, a shorted coil or a wet connector; the affected valve stops dosing.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 54

Possible causes

  • Pinched or chafed wire to injector 2 touching ground high
  • Coil resistance too low due to shorted turns (Ford definition) medium
  • Water or DEF in the injector connector low

Symptoms

  • MIL on
  • Dosing at the affected valve stopped
  • DEF warning message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2054

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication