OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P204C

Reductant Pressure Sensor Circuit Low

P204C means the DEF pressure sensor output has fallen below its valid range, which points to an open signal wire, a short to ground or a missing 5 V supply. On the 6.6 L LML, GM fails anything under 0.41 V lasting 0.4 s, GM's 2018 diesel table a raw value under 5 % of the supply, and the 2025 DEF controller less than 0.45 V in 6 of 100 samples, each Type A. Ford's 2023 diesels set it under 0.2 V. On 2017 to 2019 Super Duty trucks with the 6.7 L, Ford (TSB 19-2315) found water entering connectors C3613 and C4851 of the reductant harness and replaced harness, pump/heater assembly or tank. Deutz uses failure type 11 for it on the EMR5. Lacking a pressure value, the controller suspends dosing.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 4C

Possible causes

  • Water intrusion in the reductant harness connectors (Ford TSB 19-2315) high
  • Signal wire open or shorted to ground medium
  • Missing 5 V reference to the sensor medium
  • Failed sensor in the pump/heater assembly low

Symptoms

  • MIL on
  • DEF dosing stopped, DEF warning messages
  • Further reductant codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P204C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication