OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2049

Reductant Injection Valve Circuit High (Bank 1 Unit 1)

P2049 is the opposite electrical case for the Bank 1, unit 1 DEF injector: the low-side control line sees battery voltage, for instance through contact with a powered conductor or water inside the connector. On the 2014 Cruze diesel GM rates it Type B (two trips), whereas the LML and the 2018 diesel tables treat it as Type A; the 2018 test needs more than 11 V and counts 30 bad samples out of 60 at 100 ms. Deutz lists it for the EMR5 metering unit as an over-normal voltage or high-side short, and Ford's 2023 summary gives an injector current below 0.1 A as the trigger. GM's DEF bulletin sorts P2049 among non-tamper faults, so it brings up the emission service message rather than the tamper warning. The output stage shuts off to protect itself, which stops dosing.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 49

Possible causes

  • Control wire shorted to a supply wire in the harness high
  • Moisture or corrosion bridging pins at the injector connector medium
  • Internal fault of the DEF injector coil medium
  • Defective output stage in the control module low

Symptoms

  • MIL on (on some GM diesels only after the second trip)
  • Service emission system message
  • Higher NOx because no DEF is injected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2049

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication