P2041
Reductant Injection Air Pressure Sensor A Circuit Intermittent
P2041 catches an air pressure sensor A whose signal keeps dropping out or jumping for brief moments, too short or too irregular to be confirmed as a steady low or high fault. On trucks and machines with air-assisted DEF dosing this typically comes from vibration: a terminal with lost contact tension, a cracked wire inside the loom or moisture entering the connector at the dosing module. No manufacturer documents P2041 publicly; Deutz, which uses the same sensor slot, lists only the permanent electrical faults (P2037, P2039, P2040). CARB counts erratic signals among the circuit faults an OBD system must detect. Since the fault comes and goes, wiggle-testing the harness while watching live data is more useful than measuring at rest; replacing the sensor without that test often does not help.
Possible causes
- Terminal with lost contact tension at sensor or controller high
- Wire broken inside the insulation from vibration medium
- Moisture in the connector medium
Symptoms
- Warning lamp coming and going
- DEF dosing interrupted at times
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2041
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.