OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2040

Reductant Injection Air Pressure Sensor A Circuit High

With P2040 the injection air pressure sensor A reports a voltage above its upper limit, more than a real air pressure could produce. On Deutz's EMR L1 controller this is P2040-00 under SPN 4335, defined as a short circuit to battery. In practice that means the signal wire touches a powered conductor, the sensor ground is missing so the output floats up to the reference, or the sensor itself has failed high. A wrongly high reading is dangerous for the strategy because it could pretend that air is available when it is not, so the controller treats the signal as invalid and blocks DEF injection. Low readings are covered by P2039, implausible but in-range values by P2038. Check the ground pin first, then the harness for chafing against powered lines.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 40

Possible causes

  • Signal wire shorted to battery or another powered line high
  • Sensor ground open so the output floats high medium
  • Sensor failed with output stuck high low

Symptoms

  • Emission warning lamp on
  • DEF injection blocked
  • Air pressure value shown at maximum

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2040

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication