P2039
Reductant Injection Air Pressure Sensor A Circuit Low
P2039 is stored when the signal of injection air pressure sensor A sits below the lowest voltage a working sensor can deliver. Deutz documents it on its EMR L1 controller as P2039-00 under SPN 4335 and lumps two causes together: a grounded signal and an open circuit, since the input is pulled low when the signal wire is interrupted. A loss of the 5 V reference is another common reason for a reading near zero. Because the controller can no longer confirm that atomizing air is present, it stops DEF injection; Deutz engines then run without NOx reduction until the inducement logic of the machine steps in. The opposite fault is P2040, and electrical faults of the sensor supply fall under P2037.
Possible causes
- Signal wire open or shorted to ground high
- 5 V reference to the sensor lost medium
- Sensor output stuck low medium
Symptoms
- Emission warning lamp on
- DEF injection stopped
- Power derate after a while on machines with inducement
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2039
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.