P2037
Reductant Injection Air Pressure Sensor A Circuit
Some heavy-duty SCR systems do not spray DEF on their own pressure alone but blow it into the exhaust with compressed air, supplied by a compressor or an existing air system; Bosch's first Denoxtronic generation was built this way. A pressure sensor checks that this air is present before dosing. P2037 is the general circuit fault of that sensor. Deutz uses it on the EMR L1 controller (SPN 4335) for two failure types: a ground fault (-F0) and a sensor supply out of range (-1C), while a reading stuck low or open goes to P2039 and a short to battery to P2040. CARB names air assisted injection as part of the reductant delivery that must be monitored. With the air pressure unknown, dosing is normally stopped, and on trucks a power derate may follow.
Possible causes
- 5 V supply or ground of the sensor interrupted or shorted high
- Damaged harness or corroded connector at the dosing module medium
- Air pressure sensor failed internally medium
Symptoms
- Engine or emission warning lamp on
- DEF dosing suspended
- Engine power derate on trucks and machines
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2037
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.