P2036
Exhaust Gas Temperature Sensor Circuit High (Bank 2 Sensor 2)
P2036 is set when the bank 2, sensor 2 temperature signal climbs above the top of its valid window. On the usual pull-up input that is what an unplugged connector, a broken lead or an element gone open after heat cycling produces, while a short to supply voltage gives the same picture. No manufacturer documents P2036 publicly; Deutz files the short to battery of its second SCR inlet sensor as P2034-12, and GM's 2018 diesel tables carry all their sensors on bank 1. For the bank 1 code P2033 GM's 2018 diesel tables use a resistance equivalent above 922 ohms, confirmed by 10 failed samples, Type B. Because a dead sensor looks like an extremely hot exhaust here, the control unit may also trigger protective power reduction until the circuit is repaired.
Possible causes
- Sensing element open after repeated heat cycles high
- Connector unplugged, loose or with pushed-back terminal medium
- Sensor lead broken near the hot exhaust medium
- Signal wire shorted to supply voltage low
Symptoms
- Engine warning lamp on
- Bank 2 temperature shows an implausibly high value
- Possible protective power reduction
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2036
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.