OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2035

Exhaust Gas Temperature Sensor Circuit Low (Bank 2 Sensor 2)

P2035 reports that the signal of temperature sensor 2 on bank 2 has dropped below its plausible floor. Whether that is a short or an open depends on the sensor curve: with a thermistor pulled up by the control unit a grounded wire drags the voltage down, whereas some circuits read near zero when the loop is broken. No manufacturer documents P2035 publicly. Deutz, the one maker found using this sensor slot, keeps the short to ground under P2034-11 instead. The bank 1 counterpart P2032 shows typical limits: GM's 2018 diesels fail below a resistance equivalent of 142 ohms as a Type B code (MIL after two trips). CARB requires such out-of-range checks for every emission-relevant input. Expect the dosing or regeneration strategy that relies on this reading to be cut back.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number– / 35

Possible causes

  • Signal wire chafed through to ground on the exhaust or frame high
  • Internal short in the sensing element medium
  • Water bridging the connector pins low

Symptoms

  • Engine warning lamp on
  • Temperature reading on bank 2 implausibly low or at the limit
  • Regeneration or DEF dosing limited

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2035

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication